Posted by: larryn ®
01/16/2010, 15:26:18
Author Profile Mail author Edit
|
hi, have a problem with a 910 planer. I changed out my 2hp motor for a 5 horse and also changed the feed sprocket to the optional 20ft. a minute sprocket. After a few boards, the #33 chain came off and I fixed that by tightening a hex nut that holds the #34 feed pulley on to the infeed roller. That chain has not come off again. Then, a few boards later, the #22 roller chain popped off. I put it back on and it will pop off after a board or two. It just doesn't seem to stay lined up with the #26 pulley. I think the increased power and faster feed has created this issue on a unit which has some wear. thanks for help. larry
|
